Hot Melt Adhesive for Automobile NEL®-6100
NEL®-6100 Series is reactive polyurethane hot melt adhesive with strong bonding strength. It is suitable for car interior. Due to its excellent operation performance and environment-friendly, been widely applied to automobile industry.
Product Use

NEL®-6100 Series is reactive polyurethane hot melt adhesive with strong bonding strength. It is suitable for car interior. Due to its excellent operation performance and environment-friendly, been widely applied to automobile industry.

Physical and Chemical Property

Content

Index

Appearance:

Milky white solid

Chemical Content:

Polyurethane

Solid Content:

99.9%

Viscosity:

About 12000cps/120

Operating Time:

90-130

Density:

About 1.10g/cm3 at 20

Opening Time:

60 s (It depends on the working environment)

Curing Time:

 

48h (It depends on the temperature and humidity of the environment )

Instructions

1. Professional equipment must be used for this hot melt adhesive. The gluing methods are generally by spraying or roller coating. Ensure not contact with air in the process of using, to avoid early curing.

2. The opening time (or effective using time) after gluing closely connected with the adhesive temperature, operating ambient temperature, heat conduction performance of the bonding material and material temperature.

3. Under the high ambient humidity of gluing, or low operating ambient temperature, the effective using time after gluing will be reduced; On the contrary, will be increased.

4. Warm up first when running the machine again after stopping for a long time, observe whether the surface layer is solidified; If yes, remove the surface layer then using.

Cleaning Maintenance

Finishing the machine running then a long time not to operate, please use the specialized cleaning agent for cleaning the residual hot melt adhesive on equipment.

Please use sealant or paraffin for sealing the gluing head, nozzle etc when not working for long time, to avoid the hot melt adhesive reacts with water and air.


Security Measures

NEL-6100 is in compliance with the general chemical protection measures. Keep good ventilation in working environment, wear appropriate skin protection device and goggles in the process of using. If skin contacts with this product, wash the skin with water and soap. If eyes contact, irrigate copiously with plenty of clean and fresh water. In case of severe case, immediately seek for medical advice.

Storage Transport

Valid for 6 months to store in sealed container at 21℃. After using, keep the rest of adhesive in sealed storage and better to remove the air that contacts with adhesive.

OnlineMessage

Please input keywords

Confirm